Advertisement
SE
MOUNTING
HOLD OPEN FORCE ADJUSTMENT: Locate
hold-open adjustment screw in diagram to the
right. For greater hold open force, insert
socket screw key wrench (included in screwpack)
and turn clockwise. To decrease amount
of hold open force, turn screw counter-clockwise.
Maximum of 4 turns.
1. With power on, open door completely. Door should remain in
open position. If door does not stay open, check electrical input.
2. Push release test switch. Door should close immediately. Open
the door to hold-open position and let it remain there.
3. System should be checked at frequent intervals. It is suggested
that step 2 be repeated every 90 days.
24V AC/DC OR 120V AC/DC
(usually from alarm panel or detector)
TRACK
PLUG
(TOP)
SE TRACK
ASSEMBLY
ELECTRICAL CHECKOUT:
WIRING DIAGRAM - POLARITY NOT IMPORTANT
INPUT VOLTAGE:
FOR 12V AC/DC wiring
consult factory
END
PLUG
ADJUST.
SCREW
COVER
PLATE
CLOSER
COVER
SOLENOID
ASSEMBLY
HOLD-OPEN FORCE
ADJUSTMENT SCREW
TO EITHER TERMINAL
OPTIONAL SWITCH
TO EITHER TERMINAL
ARM
SPACER
COVER
SCREW
MOVABLE
COVER
INSERTS
(R.H. or L.H.)
TERMINAL
LEADS GROUND
TERMINAL
RELEASE
TEST SWITCH
WARNING
!
HAZARDOUS VOLTAGE
CAN SHOCK AND
CAUSE SEVERE INJURY
Disconnect power before
making any electrical
connections or performing
maintenance.
CONDUIT
HOLE PLUG
Advertisement
