Central Hydraulics 66593 Set Up And Operating Instructions Manual page 4

10-ton long frame jack
Table of Contents

Advertisement

5.
Apply the vehicle's parking brake
and chock the non-lifted tires before
raising the vehicle.
6.
Lift the vehicle only by the
manufacturer-recommended lifting
points.
7.
Stay out from under the load while it
is being lifted or supported only by
this Jack.
8.
Avoid rapid load descent. Turn the
Release Screw slowly.
9.
Do not use for aircraft purposes.
10.
Do not leave the tool unattended
when it is connected to a compressed
air supply. Release the tool's load
before leaving.
11.
This product is not a toy. Keep it out
of reach of children.
12.
When lifting only one wheel, make
sure to support the load immediately
with one jack stand (not included)
placed under the side of the vehicle
being lifted. Align the saddle of the
jack stand directly under the vehicle's
frame or recommended lifting point.
13.
When lifting the entire front end or
rear end of a vehicle, make sure to
support the load immediately with
two jack stands. Align the saddles
of the jack stands directly under the
vehicle's frame or recommended
lifting points. Also, make sure the
jack stands are adjusted at the same
height.
14.
Use the Long Frame Jack only on
vehicles whose frames have lifting
points (on its seam or frame) capable
of aligning with the Bottle Jack.
SKU 66593
For technical questions, please call 1-800-444-3353.
15.
Do not use the Jack with the vehicle's
engine running. When running, the
vehicle's engine produces carbon
monoxide, a colorless, odorless, toxic
fume that, when inhaled, can cause
serious personal injury or death.
16.
Always keep hands, fingers, and
feet away from all moving parts of
the Jack when applying or releasing
a load. Remain clear of the vehicle
being raised or lowered. People and
animals should be kept at a safe
distance when using the Jack.
17.
Do not allow anyone in the vehicle
when using the Jack. Keep all
bystanders a safe distance away
from the vehicle.
18.
Never use this Jack to lift both ends
of a vehicle at the same time.
19.
Before lowering the Jack, make sure
tool trays, jack stands, and all other
tools and equipment are removed
from under the vehicle.
20.
The warnings, precautions,
and instructions discussed in
this instruction manual cannot
cover all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
SAVE THESE
iNSTRuCTiONS.
Page 4

Advertisement

Table of Contents
loading

Table of Contents