Jenn-Air EDR3RXD1B Use & Care Manual page 24

PERFORMANCE DATA
SHEET
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.89
Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C).
Rated service capacity = 200 gallons (757 liters).
For installation, operation, and maintenance instructions please refer to
■
the Owners Manual.
It is important that operational, maintenance, and filter replacement
■
requirements be carried out for the product to perform as advertised.
Property damage can occur if all instructions are not followed.
The disposable cartridge must be changed at least every 6 months.
■
Use replacement filter part #EDR3RXD1/ EDR3RXD1B.
■
The filter monitor system measures the amount of water that passes
■
through the filter and alerts you when it is time to replace the filter. To
learn how to check the water filter status, see "Using the Controls" or
"Water Filtration System" in the User Instructions or User Guide.
After changing the water filter, flush the water system. See "Water and
■
Ice Dispensers" or "Water Dispenser" in the User Instructions or User
Guide.
These contaminants are not necessarily in your water supply. While
■
testing was performed under standard laboratory conditions, actual
performance may vary.
For installation, operation and maintenance instructions please refer
■
Owner's Manual.
*Class II particle size: >0.5 to 1 µm
Based on the use of Cryptosporidium parvum oocysts
†
Fibers greater than 10 um in length
††
® NSF is a registered trademark of NSF International.
24 | ASSISTANCE
The product is for cold water use only.
■
The water system must be installed in compliance with state and local
■
laws and regulations.
Do not use with water that is microbiologically unsafe or of unknown
■
quality without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used on disinfected waters
that may contain filterable cysts. EPA Est. No. 082047-TWN-001.
Refer to the "Warranty" section (in the User Instructions or User Guide)
■
for the Manufacturer's limited warranty, name and telephone number.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
Potable City or Well
30 psi-120 psi (207 kPa - 827 kPa)
33°F-100°F (0.6°C - 37.8°C)
0.5 gpm (1.89 L/min) @ 60 psi (413.7 kPa)