Canon 800 Instructions Manual page 33

11x17 LTR / LGL LTR R LTR STMT / STMT LTR / LTR R
(Positions image B on top)
(Positions image B on the bottom)
Import margins
This function selects whether the margins are adjusted
during scanning.
Adjust margins (default setting: P3)
This function adjusts the margin size when margins are
scanned during scanning. When you press this key, the
display shows the margin size. The margin can be
adjusted to a value between –10 mm and 10 mm either
side of 0.
Adjust sharpness (default setting: P4)
This function selects the sharpness (edge enhancement)
during scanning. When you press this key, the display
shows the sharpness setting. The sharpness can be set to
5 levels between 1 and 5.
Photo mode (default setting: F5)
This key switches the mode to picture mode. When this
key is pressed, the key lights and the scanning mode
changes to "Monochrome Photo".
Import overlay
When you press this key, the 2 images in the A and B
positions on duplex film are output one above the other
as a single image during scanning.
LGL 11x17
When you store this function and hold down the function
key for 2 seconds, the position setting display for the 2
images is shown and the programmed function key and
setting display blink.
Use the (+) and (-) keys to change the setting and the
programmed function key to confirm the selected setting.
600 DPI
This switches the scanning resolution between 600 and
300 dpi. When you press this key, or when the resolu-
tion is set to 600 dpi from the application program, the
key lights up. Conversely, when this key is pressed
again and the key lamp switches off, the resolution in
the application software is set to 300 dpi.
– 31 –
Special Features