Table of Contents
Advertisement
Device Management
3.2 Configuring the Device
3.2
Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM ROS interface. For
more information about configuring the device, refer to the "RUGGEDCOM RS8000
Configuration Manual" associated with the installed software release.
3.3
Resetting the Device
The RUGGEDCOM RS8000 can be reset (rebooted) using the RESET button. The
RESET button is recessed and can only be reached using a pin or small screwdriver.
To reset the device, quickly press and release the RESET button with a pin.
18
RUGGEDCOM RS8000
Installation Manual, 12/2021, C79000-G8976-1020-06
Advertisement
Table of Contents
