Bunn HC-2 HC-3 Operating & Service Manual page 36

SERVICE (cont.)
TRANSFORMER (240V TWO WIRE
MODELSONLY)(cont.)
Removal and Replacement:
1. Disconnect the wires from the transformer.
2. Remove the two #8-32 keps nuts securing the
transformer to the dispenser base.
3. Remove and discard the transformer.
4. Install new transformer over the two weld studs on
the dispenser base and secure with two #8-32
keps nuts.
5. Refer to Fig. 34 when renonnecting the wires.
BLK & WHI to
Fan
FIG.34 TRANSFORMER TERMINALS
RED & BLK to
Main Harness
P1288
36 27591 031597