Replacing The Dvd Drive; Preventing Static Electricity Discharge - Gateway MT6840 Hardware Replacement Manual

Replacing the DVD Drive

You need a small Phillips screwdriver to replace
Tools the DVD drive.

Preventing static electricity discharge

The components inside your notebook are extremely sensitive
to static electricity, also known as electrostatic discharge (ESD).
ESD can permanently damage electrostatic discharge-sensitive
components in your notebook.
To avoid exposure to dangerous electrical
voltages and moving parts, turn off your
Warning notebook and unplug the AC adapter, modem
cable, and network cable before replacing a
component.
Before working with notebook components, follow these
guidelines:
• Avoid static-causing surfaces such as carpeted floors,
plastic, and packing foam.
• Remove components from their antistatic bags only when
you are ready to use them. Do not lay components on the
outside of antistatic bags because only the inside of the
bags provide electrostatic protection.
• Always hold components by their edges. Avoid touching
the edge connectors. Never slide components over any
surface.
• Wear a grounding wrist strap (available at most electronics
stores) and attach it to a bare metal part of your workbench
or other grounded connection.
• Touch a bare metal surface on your workbench or other
grounded object.
Replacing the DVD drive
To replace the DVD drive:
1 Follow the guidelines under "Preventing static
electricity discharge."
2 Make sure that the DVD drive is empty.
3 Turn off your notebook.
4 Disconnect the AC adapter, modem cable, and
network cable.
5 Disconnect all peripheral devices and remove any
PC Cards.
6 Turn your notebook over so the bottom is facing up,
then remove the battery. For more information, see
"Changing Batteries" in your Reference Guide.
Technical Support
See the label on the bottom of the notebook for Customer
Care Information. See your Reference Guide for important
safety, regulatory, and legal information.
7 With a small Phillips screwdriver, remove the
keyboard screw and put it in a safe place.
Tips & Tricks
8 Loosen the six memory bay cover screws (these
screws cannot be removed), then remove the
memory bay cover.
9 With a small Phillips screwdriver, remove the DVD
drive screw, then put it in a safe place.
© 2007 Gateway, Inc. All rights reserved. Gateway and
eMachines are trademarks or registered trademarks of
Gateway, Inc. in the United States and other countries.
All other brands and product names are trademarks or
registered trademarks of their respective companies.
www.gateway.com
Replacing the DVD Drive
The keyboard screw hole is marked with a K.
Screws
Screws
Screw
Screw
1