Electrolux EUF2949GOW User Manual page 34

34 www.electrolux.com
Problem
There is no ice production. The ice maker is not
DEMO appears on the dis‐
play.
Door is misaligned or inter‐
feres with ventilation grill.
The temperature in the ap‐
pliance is too low/too high.
E1 is flashing the tempera‐
ture display.
E 2 is flashing in the tem‐
perature display.
E 3 or E 5 is flashing in the
temperature display.
Ice maker icon is flashing.
A rattling noise.
If the advice does not lead to
the desired result, call the
nearest Authorised Service
Centre.
Possible cause
switched on.
The appliance is in dem‐
onstration mode.
The appliance is not lev‐
elled.
The temperature regula‐
tor is not set correctly.
Food products placed in
the appliance were too
warm.
The door has been
opened often.
The ActionFreeze func‐
tion is switched on.
There is no cold air circu‐
lation in the appliance.
No water supply.
The ice channel in the
door is blocked.
The ice maker is defec‐
tive.
The ice container is in in‐
correct position.
The ice being stirred to
prevent it from freezing
together.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Solution
Refer to "Switching on and
off the ice maker".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Refer to "Levelling".
Set a higher/lower tempera‐
ture.
Allow food products to cool
to room temperature before
storing.
Open the door only if neces‐
sary.
Refer to "ActionFreeze func‐
tion".
Make sure that there is cold
air circulation in the appli‐
ance.
Carry out the necessary
measures on the water sup‐
ply. Press any button to re‐
set the Alarm.
Remove the obstacle. Press
any button to reset the
Alarm.
Contact the nearest Author‐
ised Service Centre.
Remove the ice container
and place it correctly. Refer
to "Removing the ice con‐
tainer".
No measure necessary, this
sound is normal. As an alter‐
native, refer to "To activate
the night mode".