Electrolux EUF2949GOW User Manual page 33

Problem
A rectangular symbol is
shown instead of numbers
on the Temperature Dis‐
play.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
Possible cause
The temperature in the
appliance is too high.
Temperature sensor
problem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The ActionFreeze func‐
tion is switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The ActionFreeze func‐
tion is switched on.
ENGLISH
Solution
Refer to "High temperature
alarm".
Contact the nearest Author‐
ised Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "ActionFreeze func‐
tion".
Refer to "Closing the door".
The compressor starts after
a period of time.
Attach the melting water out‐
let to the evaporative tray.
Switch off ActionFreeze
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "ActionFreeze function".
33