Advertisement
Connect hot and cold water supply
(Fig.1):
1. Fix the water inlet hose with the red stripe
at the red valve of the washing machine and
at the hot water tap.
2. Fix the water inlet hose with the blue stripe
at the white valve of the washing machine
and at the cold water tap.
To get the optimum performance you should
use both the hot and cold water supplies.
Make sure:
a) The connections are tight, but do not over
tighten by using a tool.
b) Do not invert their position
(for example: cold fill into hot inlet valve
and viceversa).
c) And see instruction for use "Connect the
water supply hose".
HOT / COLD FILL INSTRUCTION
Please observe that both inlet valves (red and white) of the washing
machine have to be connected to the water supply. There are two
alternative ways of doing this:
Cold fill
White inlet valve
Red inlet valve
Fig.1
Do not allow children to operate, crawl on, near or inside your washer.
Note that during wash cycles, the surface temperature of the porthole
door may increase.
Close supervision of children is necessary when the appliance is used
near children.
Cold fill
Hot fill
Y-piece
White inlet valve
Red inlet valve
Fig.2
Connect cold water supply only
(Fig. 2):
1. You need a Y-piece connector, which can
be ordered via our Service Organization
(see Instructions for Use) or purchased in
a specialized hydraulic component store.
2. Fix the Y-piece connector to the cold fill
tap.
3. Connect the two inlet valves on the rear
part of the machine to the Y-piece
connector. Fix the hose with the red
stripe at the red valve, and the hose with
the blue stripe at the white valve of the
washing machine.
Make sure all connections are tightly
fixed.
Programme times might differ from the
times indicated in the Consumption
Data table if the washing machine is
connected to cold fill only.
Whirlpool is a registered trademark of Whirlpool USA
5019 301 15210
Advertisement
