Table of Contents
Advertisement
Removing Valve
If your valve requires maintenance or replacement,
use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1) If optional fan is installed, disconnect power
source to stove.
2) Remove access panel.
3) Disconnect gas line to stove.
4) Disconnect 3/8" NPT pipe from 90
on valve or flex connector.
5) Disconnect the two (2) switch wires from
valve.
6) Lift off Cast Top, remove Cast Front and remove
Glass Door. See the "Glass Replacement" sec-
tion for removal instructions.
7) Carefully remove the logs and embers.
Hampton® H15U-NG/LP Direct Vent Freestanding Gas Stove
8) Remove burner by removing the 2 screws on
each side, slide the burner to the left and then
lift the burner tray out.
Note: Use a magnetic type screwdriver if pos-
sible.
9) Remove all 8 screws holding the burner tray
assembly in place. Remove deflector.
o
elbow
10) Carefully lift the burner tray assembly out.
Screws
maintenance
11) To remove the valve, remove the 4 screws (2
per bracket) that hold the valve to the valve
bracket assembly.
12) To replace the burner tray assembly, simply
reverse these instructions.
To remove valve from valve assembly, continue.
13) Remove two (2) thermopile wires.
14) Remove thermocouple with a 9 mm (metric)
wrench.
15) Remove pilot nut with an 11 mm wrench.
16) Remove valve to orifice nut with a 13/16" wrench.
17) Remove inlet pipe with pipe wrench. Note
orientation of 90
elbow.
o
18) Remove two (2) phillips head M5 screws on
each side of the valve.
19) Remove valve and remove gas out 90
fitting. Note orientation of fitting.
Installing Valve Assembly
1) To install a new valve assembly, reverse instruc-
tions for Removing Valve.
2) Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3) To reinstall valve, reverse instructions for remov-
ing valve assembly, steps 11-20.
o
brass
45
Advertisement
Table of Contents
