Pentax MZ-S Service Manual page 14

2 2 2 2 - - - - 3 3 3 3 .Install bottom side of 0 .Install bottom side of 0 .Install bottom side of 0- - - - T100. .Install bottom side of 0
1） DT(5x10)･･･On the bottom base plate, Key box side.
2） TY-CNL-D1.4x4.0･･･ at around the hole
2 2 2 2 - - - - 5.0 5.0 5.0 5.0- - - - T100 and soldering. T100 and soldering. T100 and soldering. T100 and soldering.
1） Top portion of grip side･･･Install A339-1 screw(TY-CNL-D 1.7X4.0), 4 lands on 0-Q200, 5 lands
on 0-I240･0-T27, 1 land on A34, 1 lead wire(No.2, Black).
2） Slanted portion of right and front on Penta Prism.･･･4 lead wires on (0-G100･0-S200,
5 lands on T81, Flexi.joint portion on T71.
3） On the left Inclined plain of Penta Prism･･･ Adhere 0-J100 contact flexi.(DT 5x7),
6 lands(0-J100), 1 lead wire(No.24 Black).
4） DX contacts･･･9 contacts, 3 lands(T64)
5） Main Body left･･･１screw, 11 lands(T61), 3 lead wires (No.8 Yellow, No.9 Purple, No.23 Red)
6） 0-I220･･･ 1 screw(Check SW/On).
7） Bottom side･･･15 lands(T301･0-T100 relay flexi.), 10 lead wires(A36,A37,0-I220,0-S250,
0-S300)
8) Arrange lead wires･･･DT(4x10), PT(9x15).
(0-S200) Red, Black
TY-CNL-D1.7x4.0 0-I240/0-T27(5)
A34 Black (A35)
TY-CNL-D 0-I220
1.7x5.0
T100. T100. T100.
of Tri-pod seat.
(0-G100)
Gray
Orange
T81 (5)
2 2 2 2
1 1 1 1
6 6 6 6
0-Q200(4)
(A37,A36)
Black
Red
DT(4x10)
PT(9x15)
0-T100(8) Blue White
27640 -13/34-
TY-CNL-D
1.7x4.0
DT(5x7) 0-J100(6)
Black
2 2 2 2
3&5 3&5 3&5 3&5
7&8 7&8
7&8 7&8
(0-S300) Pink White
Orange
Red
(0-I220) Black (N300)
DT(5x10)
T61(11)
Yellow Purple TY-CNL-D
1.7x4.0
R110/R120 (9)
4 4 4 4
Red Black (0-S250)
Gray
(0-S300)
T301(7)
Red
T64 (3)