Install Mount Plate - Ferris Simplicity FAST-Vac Operator's Manual

B
A
Figure 21. Install Mount Plate
A. 3/8-16 Nylon Lock Nuts
B. Mount Plate
C. Bar Clamps

Install Mount Plate

(Ferris IS3000Z Series & Derby Stallion ZT2561)
1. Install the mount plate (B, Figure 21) on the bumper
using three bar clamps (C), six 3/8-16 x 2-1/2" bolts
(D) and 3/8-16 nylon lock nuts (A). Make sure the
top right bolts (circled) are on the outside of the verti-
cal bumper tube. Push the mount towards the left
until the top right bolts rest against the vertical
bumper tube and tighten securely.
04
3-Bag Hood & Mount Installation
D
C
D. 3/8-16 x 2-1/2" Bolt
E. 3/8-16 x 1" Bolt
F. 3/8-16 Flange Nuts
B
E
Install Mount Plate
(Derby Stallion ZT2561F)
1. Install the mount plate (B, Figure 21) on the bumper
using four 3/8-16 x 1" bolts (E) and 3/8-16 flange
nuts (F). Tighten hardware securely.
If there are NO holes in the bumper:
1. Drill one 3/8" hole, at the dimensions shown in
Figure 21.
2. Install the mount plate (B) using one 3/8-16 x 1" bolt
and 3/8-16 flange nut. Make sure the mount plate is
square with the bottom edge of the lower bumper.
This is critical. Tighten securely. For additional sup-
port, use a clamp to secure the bottom edge of the
mount plate to the lower bumper.
3. With a 3/8" drill bit, use the three (3) holes shown
above with bolts (E), in the mount plate as a guide
and drill through the rear shield and lower bumper.
4. Install the remaining 3/8-16 x 1" bolts (E) and 3/8-16
flange nuts (F) and tighten securely.
13
F
4-3/4" (12cm)
1-1/8" (2,85cm)