Logging In To Your Gateway; Configuring The Wan Manually - ADTRAN SMART/RG SR700ac Quick Start Manual

Hide thumbs Also See for SMART/RG SR700ac:

Table of Contents

Warning:

Do not press the

circular hole on the rear panel. If you want to restore the default settings, insert a thin wire (such as a paper clip) into the

hole, press the

Reset

button gently for 1 second, and then release the button. The system reboots and returns to the

factory defaults.

Logging in to your gateway

To change the settings on your gateway, you must log in to the gateway's interface. Make sure that you have completed the

steps in "Installation" before you begin.

1. Open your internet browser application and type 192.168.1.1 into the address line. The login dialog appears.

2. Enter the factory default credentials shown below and click OK.

User

Note: Your service provider may use other settings. Contact your provider for details.

3. At the bottom of the page, click

If the automatic connect process is unsuccessful, refer to the

sections of the SmartRG SR700ac Gateway User Manual to manually establish a connection.

Reset

button unless you want to clear the current settings. The

Name: admin

Manage gateway

Password: admin

(advanced). The gateway interface appears.

Advanced Setup

Reset

button is in a small

Layer2 Interface

and

WAN Service

Table of Contents