Mounting On The Dashboard - Garmin Mobile 20 Set Up And Go Manual

Mounting the GPS 20SM
Select a location for the GPS 20SM. To receive satellite
signals, place the GPS 20SM where it has a clear view
of the sky. To communicate, the GPS 20SM must be
within 10 meters (about 30 feet) of your mobile phone.
Clean and dry the selected area of the windshield.
Volume/hands-free
➊
Adapter cable connector
to power the phone
Power cable to power the GPS 20SM
1. Snap the phone mount onto the suction cup
mount.
2. Place the suction cup on the windshield.
3. Flip the lever back, toward the windshield.
Garmin Mobile™ 20 set up and go!
Windshield
➋
wheel
Lever
➌
Tab
To remove the phone mount from the suction cup
mount, turn the phone mount as far as you can to the
right or left. Apply pressure in that direction until the
phone mount pops off the suction cup mount.
To remove the suction cup mount, flip the lever toward
you. Pull the tab on the suction cup toward you.
NOte: If state or local laws prohibit the use of
suction cup mounts, or if your phone opens vertically
and the windshield has a steep angle, you may need
to use the dashboard disk.

Mounting on the Dashboard

Important: The permanent mounting adhesive is
extremely difficult to remove after it is installed.
1. Select a location on your dashboard where the
GPS 20SM will have a clear view of the sky.
2. Clean and dry the selected area of the dashboard.
3. Remove the backing from the bottom of the disk.
4. Place the disk on the dashboard.
5. Place the suction cup mount on top of the disk.
Flip the lever down (toward the disk).