Stihl MS 382 Instruction Manual page 47

2 Safety Precautions
Always hold the chain saw firmly with both
hands: Right hand on the rear handle – even if
you are left-handed. To ensure reliable control,
wrap your thumbs tightly around the handlebar
and handle.
In the event of impending danger or in an emer‐
gency, switch off the engine immediately by mov‐
ing the Master Control lever / stop switch to
STOP, 0 or †.
Never let the machine run unattended.
Exercise caution with slippery surfaces, water,
snow, ice, steep slopes, uneven ground or green
wood that has just been stripped of its bark –
danger of slipping!
Use caution with tree stumps, roots, ditches –
danger of stumbling!
Do not work alone – keep within calling distance
of others who are trained in emergency proce‐
dures and can provide help in an emergency.
Helpers at the cutting site must also wear protec‐
tive clothing (helmet!) and stand well clear of the
branches being cut.
More care and attention than usual are required
when wearing ear protection, as warning sounds
(shouts, beeps, etc.) cannot be heard properly.
Take a break in good time to avoid tiredness or
exhaustion – risk of accidents!
Dust (e. g., sawdust), fumes and smoke pro‐
duced while using the machine may be hazard‐
ous to health. If dust is generated, wear a dust
mask.
When the engine is running: Note that the saw
chain continues to rotate for a short period after
you let go of the throttle trigger – coasting effect.
No smoking when working with or near the chain
saw - risk of fire! Combustible fuel vapour may
escape from the fuel system.
0458-562-8721-B
Examine the saw chain periodically at short inter‐
vals and as soon as you note any tangible
changes:
– Switch off the engine; wait until the saw chain
is stationary
– Check condition and secure fitting
– Check sharpness
Never touch the saw chain when the engine is
running. If the saw chain becomes jammed by an
object, switch off the engine immediately before
attempting to remove the object – risk of injury!
Always turn off the engine before leaving the
machine unattended.
To change the saw chain, switch off the engine.
Risk of injury from the motor starting unintention‐
ally!
Keep easily combustible materials (e. g., wood
chips, bark, dry grass, fuel) away from hot
exhaust gases and hot mufflers – risk of fire!
Mufflers with catalytic converters can become
especially hot.
Never work without chain lubrication – monitor
the oil level in the oil tank. Stop work immediately
if the oil level in the oil tank is too low and top up
with chain oil – see also "Topping up with chain
oil" and "Check chain lubrication".
If the machine is subjected to unusually high
loads for which it was not designed (e. g., heavy
impact or a fall), always check that it is in good
condition before continuing work – see also
"Before starting work".
Check the fuel system for leaks and make sure
the safety devices are working properly. Never
continue using a machine that is not in perfect
working order. In case of doubt, have the unit
checked by your servicing dealer.
Check for correct idling, so that the saw chain
stops moving when the throttle trigger is
released. Check the idle setting regularly and
correct when possible. Have the machine
repaired by a STIHL servicing dealer if the saw
chain still continues to move during idling.
The chain saw produces poisonous
exhaust gases as soon as the engine
starts. These gases may be colour‐
less and odourless and may contain
unburnt hydrocarbons and benzene.
Never work with the machine indoors
or in poorly ventilated areas, even if
your machine is equipped with a cata‐
lytic converter.
English
47