Replacing The Light Bulbs - GE Profile PSSF3RGZ Owner's Manual And Installation

Replacing the light bulbs.

Setting the controls to OFF does not remove power to the light circuit.
Reveal appliance bulbs are used on some models. They can be identified by their blue color when they
®
are not illuminated.
Not all features are on all models.
Your light shield will look like
one of the following:
Tabs
OR
Pocket
18
Refrigerator Compartment—Upper Light
Unplug the refrigerator.
The bulbs are located at the top of the
compartment, inside the light shield. On
some models, a screw at the front
of the light shield will have to be removed.
On other models, the screw
is located in the pocket located
at the back of the light shield.
To remove the light shield, on some
models, press in on the tabs on the sides of
the shield and slide forward and out. On
other models, just slide
the shield forward and out.
Refrigerator Compartment—Lower Light
This light is located above the top drawer.
Unplug the refrigerator.
Remove the convertible meat drawer
control knob by pulling straight out.
Lift the light shield up and pull it out.
Freezer Compartment
Unplug the refrigerator.
Remove the shelf just above the light
shield. (The shelf will be easier to remove if
it is emptied first.) On some models, a
screw at the top of the light shield will need
to be removed.
To remove the light shield, press in
on the sides, and lift up and out.
Dispenser
(on some models)
Unplug the refrigerator.
The bulb is located on the dispenser under
the control panel.
Remove the light bulb by turning
it counterclockwise.
After replacing the bulb with an appliance
bulb of the same or lower wattage, replace
the light shield and screws (on some
models). When replacing the light shield,
make sure that the tabs at the back of the
shield
fit into the slots at the back of the light
shield housing.
Plug the refrigerator back in.
After replacing the bulb with an appliance
bulb of the same or lower wattage, replace
the shield and
the knob.
Plug the refrigerator back in.
Replace the bulb with an appliance bulb
of the same or lower wattage, and
reinstall the light shield. When
reinstalling the light shield, make sure
the top tabs snap securely
into place. Replace the screw
(on some models).
Reinstall the shelf and plug the
refrigerator back in.
Replace the bulb with a bulb of the
same size and wattage.
Plug the refrigerator back in.