Table of Contents
Advertisement
2. Brand Label
Select the accessory brand label according to the production order.
Attach the accessory brand logo label to this area.
The box
is to verify your work. Each task to verify that it has been done.
3. Installation Work
[3.1 Selection of Installation Place]
1. Select a suitable staging area in which to assemble the unit. With the customer's approval, determine the best
placement of the assembled unit. Choose a safe, sequestered area where the inquisitive can't reach it, and keep it
out the way of any direct air discharge.
[3.2 Prior to Installation]
1. This packing contains the following parts.
[A] Wired Controller (Qty.: 1 - For Operation Control)
[B] Screw <M4x16L> (Qty.: 2, For securing the mounting bracket to the wall.)
[C] Operation Manual (Qty.: 1)
[3.3 Installation Procedures]
1. Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and turn the
slotted screw driver to separate and remove the controller from the holding bracket.
Groove Part
6
This Area
Approx. 0-15/64 inch
Approx. 5/16 Inch
(6mm)
(8mm)
Slotted
Screw Driver
Figure Seen from Bottom Side
Menu
On/Off
OK
Back/Help ECO
O
Back Cover
Groove for Attaching Controller
More than
2 Inches
(51mm)
P5415484
Advertisement
Table of Contents
