Electrolux EDS7051 User Manual page 5

Water Connection
Water tap must be installed within 110 cm of your
dryer's water inlet and the tap must be 3/4 inch BSP
thread for laundry hose connection. Water pressure
must be between 200kpa to 800kpa.
Use the hose supplied with the dryer. DO NOT USE
OLD HOSES.
To connect the water inlet to dryer:
1.
Turn off water supply
to washer.
2. Remove inlet hose from water supply.
3. Turn on water supply for a short time to run some
water into a bucket or container to clear any
contaminants in the line.
4. Connect the Y-Connector to the water tap.
Check rubber
seal
water tap
Check rubber seal,
replace if worn.
5.
Connect the inlet hose for the washer and the dryer
to the Y-Connector and tighten them.
6. Turn on the water tap and check for leaks at all
connection.
ENGLISH 5
Water Tap
To Washing
Machine