Filling The Magazine Shaft; Setting The Impact Force; Operation; Switch On - Parkside PAT 20-Li A1 Original Instructions Manual

Filling the magazine shaft

Remove the battery before carrying out any
work on the power tool (e.g. maintenance,
changing tools, etc.) as well as during the
transport and storage of the power tool.
Unintentional activation of the trigger can result in
injury.
♦ Remove the battery pack
♦ Turn the appliance around.
♦ Press the release
♦ Pull the magazine slider
(see fig. B).
♦ Fill the magazine shaft
(see fig. C).
NOTE
► Ensure the correct position for the nails (see
main diagram, face plate
ance).
♦ After filling, push the release
zine shaft as far as the stop until it clicks into
place.
NOTE
► The fill level indicator
magazine contains staples.
│ GB │ MT
■ 50
from the appliance.
together (see fig. B).
backwards
with staples or nails
on the appli-
into the maga-
shows whether the

Setting the impact force

NOTE
► Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as
hardness of the material you are working
with.
Increasing the impact force
♦ Turn the impact force control
Reducing the impact force
♦ Turn the impact force control

Operation

Switch on

♦ Press the tacker nose
the material that you want to staple until it is
pushed in a few millimetres.
♦ Press the trigger

Switching on the LED work light

♦ Press the button for the LED work light
illuminate your workspace in unfavourable
lighting conditions.

Troubleshooting

Cause
A staple is blocking the appliance.
Solution
♦ Remove the battery pack
♦ Turn the appliance around.
♦ Press the release
♦ Pull the magazine slider
(see fig. B). This will release the tension.
♦ Remove the staple.
WARNING!
■ Do not hold the power tool by the trigger
if the staple is jammed in the power tool.
While removing a jammed staple, the
trigger can be accidentally activated.
clockwise.
anticlockwise.
onto the location on
.
from the appliance.
together (see fig. B).
backwards
PAT 20-Li A1
to