Honda CBR1000ST Manual page 231

Table of Contents

Advertisement

20200103191036_32MKR8000_eng_BOOK Page 231 Friday, January 03 2020 19:24:26 JST
Instruments, Controls, & Other Features
Ignition Cut-off System
IMU (Inertial Measurement Unit) sensor
automatically stops the engine and fuel pump if
the vehicle falls over. To reset the IMU, you
must turn the electrical system off and back to
on before the engine can be restarted.
If a failure of the IMU is detected, the engine
and fuel pump will not stop automatically when
the vehicle falls over.
HESD
The Honda Electronic Steering Damper (HESD)
automatically controls the steering damper
characteristics in accordance with vehicle speed
and acceleration.
HESD Indicator Comes On
228
Assist-slipper Clutch System
The assist-slipper clutch system helps to prevent
the rear tyre from locking up when the
deceleration of your vehicle produces a strong
engine braking effect. It also makes the clutch
lever operation feel lighter.
Use only MA classification engine oil for your
vehicle. Using engine oil other than MA
classification oil could result in damage to the
assist-slipper clutch system.
Throttle by Wire System
This model is equipped with a Throttle by Wire
System.
Do not put magnetized items or items
P. 199
susceptible to magnetic interference near the
2
right handlebar switches.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cbr1000spCbr1000st ed

Table of Contents