Honda CBR1000ST Manual page 217

20200103191036_32MKR8000_eng_BOOK Page 217 Friday, January 03 2020 19:24:26 JST
Tyre Puncture Removing Wheels
u
Install the left brake caliper and tighten
8.
the mounting bolts.
Torque: 40 N·m (4.1 kgf·m, 30 lbf·ft).
Install the right brake caliper and tighten
9.
the mounting bolts.
Torque: 40 N·m (4.1 kgf·m, 30 lbf·ft).
Take care to prevent the brake caliper
u
from scratching the wheel during
installation.
Use new mounting bolts when
u
installing the brake caliper.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Lower the front wheel on the ground.
10.
Apply the brake lever several times. Then,
11.
pump the fork several times.
214
Retighten the right axle pinch bolts.
12.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft).
Raise the front wheel off the ground
13.
again, and check that the wheel rotates
freely after you release the brake.
Install the harness guide.
14.
Uncover the protective tape or cloth.
15.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.