Cadillac CT4 Owner's Manual page 35

Cadillac CT4 Owner Manual (GMNA-Localizing-MidEast-15283644) - 2022 -
CRC - 7/28/21
remote key when entering the vehicle.
Perform the following if the welcome
message is not displayed:
1. Move all remote keys away from
the vehicle.
2. Start the vehicle with another
remote key. A DIC welcome
message should display indicating
the driver number of the other
remote key. Turn the vehicle off
and remove the other remote key
from the vehicle.
3. Start the vehicle with the initial
remote key. The DIC welcome
message should display the driver
number of the initial remote key.
Saving Seating Positions
Read these instructions completely
before saving memory positions.
To save preferred driving positions to
1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY. A DIC welcome
message may indicate the driver
number of the current remote key.
See Identifying Driver Number
previously in this section.
2. Adjust all available memory
features to the desired driving
position.
3. Press and release SET; a beep will
sound.
4. Immediately upon releasing SET,
press and hold memory button 1 or
2 matching the current Driver s
remote key number until two beeps
sound. If too much time passes
between releasing SET and pressing
1 or 2, the two beeps will not
sound indicating memory position
were not saved. Repeat Steps 3 and
4 to try again.
5. Repeat Steps 1 4 for the other
remote key 1 or 2 using the other 1
or 2 memory button.
It is recommended to save the
preferred driving positions to both
1 and 2 if you are the only driver.
To save the common exit seating
position to that is used by all
drivers for Manually Recalling Seating
Positions and Auto Seat Exit Memory
Recall features, repeat Steps 1 4 using
, the exit button.
SEATS AND RESTRAINTS
Manually Recalling Seating
Positions
Press and hold 1, 2, or button until
the recall is complete, to recall the
positions previously saved to that
button.
Manual Memory recall movement for
1, 2 or buttons may be initiated
and will complete to the saved
memory position if the vehicle is in or
out of P (Park).
Enable Automatic Recalls under
Vehicle Personalization Settings
For Seat Entry Memory that begins
movement to the preferred driving
position of the 1 or 2 button when
the vehicle is turned on, select the
Settings menu, then Vehicle, then
Seating Position, then Seat Entry
Memory, and then Select ON or
OFF. See Auto Seat Entry Memory
Recall later in this section.
For Seat Exit Memory that begins
movement to the preferred exit
position of the button when the
vehicle is turned off and the driver
door is open or opened, select the
Settings menu, then Vehicle, then
35