Table of Contents
Advertisement
Accessories
Accessories and torches configuration can be accessed
from the Home Menu by pushing knob button and
selected "Remote Control" icon and push knob again.
When activated, a new icon appears on the right of
"Remote Control" icon named "Remote range".
Hand Remote
Usable for GTAW and SMAW process.
The current displayed correspond to the position of the
remote control potentiometer from minimum to maximum
current.
Minimum and maximum can be defined in the "Remote
Range". In above example, the minimum current is 5A
and the maximum is 270A for GTAW and 250A for
SMAW
Foot Pedal
Usable in GTAW only.
When selected, the maximum current is the one set on
"Home" page by the knob. The minimum current is, like
"Hand Remote", the one set on Remote Range section.
As much the pedal is pushed, as much the current will
decrease.
Potentiometer Torch
Usable in GTAW and SMAW
"Potentiometer torch" has the same behavior than "Foot
Pedal"
English
Amperage UP-DOWN Torch
Usable in GTAW only.
Three operating modes, corresponding to different states
of the machine, are identified:
Before welding: pressing the UP or DOWN key
causes a change of value of the Set current
While welding: pressing the UP or DOWN key causes
a change of
value of the Set current during all
phases of welding process except during the start
functions, where the UP/DOWN function is masked.
Pre/post Flow: pressing the UP or DOWN key causes
a change of value of the Set current.
The change will be realized in two ways depending on
pressed button time:
Step function
Pressing the UP/DOWN button for a minimum time of
200ms and releasing it, causes the set current
raises/falls of 1A.
Ramp function
Pressing the UP/DOWN button for a time greater
than 1 sec., the set current start to increase/decrease
with a (5A/s) ramp. If press for more than 5 sec
increase/decrease with a ramp of (10A/s).
The current ramp will end when the UP/DOWN button
previously pressed is released.
17
English
Advertisement
Table of Contents
