Lincoln Electric INVERTEC 275TP Operator's Manual page 12

Welding GTAW process
To select, TIG mode process, select the GTAW icon
and push the knob button.
Home menu
1
Figure 6
1. "Main Menu" access, push this button to go back.
2. Push button to configure all parameter of current
process.
Turn the knob to adjust the welding current value.
3. "Memories" access. See dedicated Section.
Configure Parameters
Arc Strike
Figure 7
To select the type of arc striking: HF or Touch Start,
select the corresponding menu and push the Knob.
English
3
2
Select the arc strike type desired.
Weld sequence configuration
Select "Weld Sequence" menu to configure the
following parameters:

Pre-Gas time

Start current

Ramp-up time

Welding current

Ramp-down time

End current

Post-gas
For each parameters, use the knob to reach
corresponding part of the weld sequence and push
knob button.
10
Figure 8
Figure 9
Figure 10
English