Troubleshooting - GE Profile Advantium SCB2000F Owner's Manual

Questions?
Problem
Use this
LIGHTS
problem
There is no oven
solver
light on during
microwave cooking
Light during a
speedcook cycle
dims and cycles on
and off, even at full
power levels
Light visible around
the door and outer
case while
speedcooking
FAN
Fan continues to run The oven is cooling.
after cooking stops
Oven vent emits warm This is normal.
air while oven is on
Fan comes on
automatically when
using the microwave
COOKING
The oven makes
unusual sounds
while cooking
Smoke comes out
of the oven when
I open the door
Food is not fully
cooked or browned
at the end of a
cooking program

Troubleshooting

Possible Causes
This is normal. The
glass is too dark for
a microwave light.
This is normal.
Power level has been
automatically reduced
because the oven is hot.
This is normal.
This is normal.
Clicks and fans blowing
are normal. The relay
board is turning the
components on and off.
Food is high in fat
content. Aerosol spray
used on the pans.
Programmed times
may not match the size
or amount of food you
are cooking.
There may be grease
build-up on the glass
covers.
Advantium Oven
What To Do/Explanation
• Press MICROWAVE/OVEN
LIGHT button to light the oven.
• This is normal. The oven senses the
heat level and adjusts automatically.
• When the oven is on, light may
be visible around the door and
outer case.
• The fan will automatically shut off
when the internal parts of the oven
have cooled.
• If the microwave is used after
speedcook and the oven senses
that it is too hot, the vent fan comes
on to cool the oven.
• These sounds are normal.
• Smoke is normal when cooking high-
fat foods. Use vegetable oil or olive
oil on the meat itself instead of
coating the entire pan.
• Increase or decrease time for
doneness or adjust the upper or
lower lamps for browning; change
the microwave power for doneness.
• Clean the light covers with a scraper.
35