Under-Cabinet Mounting; To Drill From Inside - GE Monogram ZEM200BF Installation Instructions Manual

Tools and materials
Under-cabinet
required:
mounting
• Flat-blade screwdriver
• Phillips screwdriver
• Drill and 1/4" bit
• Nail or center punch
• Pencil and ruler
• Scissors
• Hammer
• Tape
• Safety glasses
• Two brackets (supplied)
• Place template 2 inside the cabinet:
To drill
from inside
• If you have a partition, you must:
Buttons
• Carefully remove the four plastic plug buttons
from oven top and the two screws at top rear
flange of case.
• Remove the two top case screws on the back
of oven. Retain screws.
• Select correct template and rear brackets for
this model. (See Template/Rear Bracket
Reference Sheet.)
• Secure the two rear brackets to back of the
oven, left and right, using screws removed
earlier.
–Make sure brackets are level and flush with
top surface of case.
• Cut Template 1 along dotted lines.
–If cabinet is less than 12" deep, cut off front
edge of template to fit, using template cut
lines as a guide.
–If cabinet has a recessed shelf, measure the
thickness of the front rail and cut that
amount off the front edge of template.
This will allow template 2 to lie flat.
–Cut Template 2 into 2 pieces to fit each
side of the partition.
–Position one piece of Template 2 inside the
cabinet with front edge even to cabinet
front edge.
–Position template 1 on front of the cabinet
so that the arrow is aligned with the hole
center line on template 2.
Installation
15 13/32"
Template 1
Mounting holes for the oven should be drilled
from the inside, if cabinet shelves are remov-
able to allow enough space. Holes may be
drilled from bottom, if necessary.
Micr owav e Oven
Case
Right Side
Emboss
Left Side
Template 2
12