Advertisement
Step 6
Assembling the Trim Kit Frame
Assemble Top Trim (4), Bottom Trim (5)
and Side Trims (6) shown with the #6 x
1/2"L flat head thread-forming screws
(D). Fasten through holes in the Trim Kit
Sides (6) as shown.
CAUTION: After assembly, top, bottom
and side strips must be flush.
Note: Bottom Trim (5) has a hinge
notch and is not interchangeable
with Top Trim (4).
Step 7
Installing the Trim Kit Frame
1. Using the assembled Trim Kit Frame as a
template (and with the microwave oven in
position and secured), insert the Trim Kit
Frame into the cutout and locate the
attaching holes. Temporarily hold the
Trim Kit Frame in place by starting the
four screws that attach the trim kit frame
to the Base Pan and Side Covers. Push the
Trim Kit Frame as far to the left as possible
driving the four inside screws into Base
Pan and Side Cover. Be sure the door
clears the trim when open. Mark the four
holes on the side trim.
2. Remove the Trim Kit Frame.
3. Center punch and drill 3/32" dia. pilot
holes per their hole center marks for the
mounting screws.
4. Position the assembled Trim Kit Frame
around the Oven and secure it with 8
screws (C). Use the smaller Phillips head
screwdriver (#1) to prevent burring the
Phillips head.
Part No. 245B1790P064 (2)
Pub. No. 31-1163 (2)
Screw D
Side
Trim
(6)
Screw D
Bottom Trim (5)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Top Trim (4)
Wall Installation
CAUTION: Do not overtighten screws
since it can cause misalignment of top/
side strips.
Screw C
Screw D
Screw D
Side Trim (6)
Screw D
Mark
Mark
Trim Kit Frame
(N.D. 558) 7/02
Advertisement
