Advertisement
Parts
2. Grub screw
4. Rear grille
4. Rear grille
screws
screws
1. Front grille
15. Safety screw
5. Rear grille
3. Fan blade
fixing bar screws
Control/Display Panel
6
6. Motor shaft
7. Control panel/
display
8. Fan motor
9. Motor fixing hole
10. Fixing bar hole & long
bolt & washer.
14. Bracket &
13 Wall bracket
Remote
Assembly
Mount to the wall
1. Determine the desired location of the wall fan (must be 1.8m from the floor) and
ensure the wall is structurely sound to cope with the load of the fan.
2. Hold the wall bracket (13) in position, and mark the screw holes with a pencil.
Ensure everything is marked horizontally and aligned before drilling.
3. Drill the holes where the pencil marks are to suit the 4 x fixing anchors (12).
4. Mount the wall bracket (13) on the wall with the 4 x fixing anchors (12)
Assemble the motor to the fixing bar
1. Attached the fan motor (8) to the fixing bar (11) by aligning the motor fixing hole
(9) with the fixing bar hole (10) and use the long bolt and washer supplied to
secure.
2. Place the bottom of the fixing bar (11) into the wall bracket (13) and use the
bracket fixing pole screws (14) to tighten and secure to the bracket.
Attach the rear grille
1. Align the rear grille (5) to motor shaft (6) on the fan motor (8) and ensure the
11. Fixing bar
hole for the safety screw is at the bottom. The 4 screw holes on the front of the
fan motor (8) should line up. Firmly tighten all four rear grille screws (4).
12. Fixing
Attach the fan blade
anchors
1. Once the rear grille (5) is attached to the fan motor (8), turn the motor shaft
(not included)
(6) so the flat area is at the top. Slide the fan blade (3) all the way onto the
motor shaft (6) and firmly tighten the grub screw (2) by rotating in a clockwise
direction.
Attach the front grille
1. Once the fan blade is fixed, align the top locking clip on the front grille (1) so it
fixes to the that of the rear grille (5). Lock the side and bottom clips in place.
2. Secure the front & rear grille, by inserting and fixing the safety screw (15) and nut.
TIP: the logo should be horizontal.
Remote
Insert 1 x A23 12V batteries (not included) into the remote.
7
Advertisement
