Owner Service 15 - Woods RB750-4 Operator's Manual

Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A P HYS ICIA N IM ME DIATE LY IF FLU ID
ENTERS SKIN OR EYES. DO NOT DELAY.
Before working underneath,
instructions, securely block up, and check stability.
Secure blocking prevents equipment from drop-
ping due to hydraulic leak down, hydraulic system
failure, or mechanical component failure.
Never perform service or maintenance with
engine running.
Before dismounting power unit or performing
any service or maintenance, follow these steps:
disengage power to equipment, lower the 3-point
hitch and all raised components to the ground,
operate valve levers to release any hydraulic pres-
sure, set parking brake, stop engine, remove key,
and unfasten seat belt.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head.
BLADE CUTTING EDGE
To reverse the cutting edge
1. Remove the 5/8" plow bolts.
2. Remove the cutting edge from the moldboard and
reinstall with the sharp edge down.
3. Replace cutting edge when both edges are worn.
MAN0160 (Rev. 8/19/2005)
OWNER SERVICE
ARNING
read manual
LUBRICATION
Weekly
Oil the pivot pins with SAE 30 oil.
8 Hours
Grease optional skid shoes.
Bolts
1. Check bolts periodically to be sure they are tight.
2. Replace bolts as needed.
NOTE: Replacement bolts must have the same
strength markings on the heads. Refer to bolt torque on
page 52.
CLEANING
After Each Use
●
Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
●
Inspect machine and replace worn or damaged
parts.
●
Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
●
Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
●
Remove the remainder using a low-pressure water
spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
●
Inspect machine and replace worn or damaged
parts.
●
Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
●
Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.

Owner Service 15