Rep 1.4 Jam Clearance And Top Cover - Xerox Phaser 3020 Service Manual

REP 1.4 Jam Clearance and Top Cover

Parts List on PL 2.1
Removal
Switch Off the Printer and unplug the Power Cord.
Jam Clearance Cover Removal
1. Remove the Left and Right Side Covers
2. Remove the Rear Cover (REP 1.3).
3. Open the Jam Clearance Cover, and release the cover support arms (2) on each side of
the cover (Figure 1).
4. Release the Jam Clearance Cover from the pivots.
5. Release the left pivot first and remove the cover
IMPORTANT
When the Jam Clearance Cover is being replaced, remove the Tag Matrix from the old
cover and install it on to the new Cover
Tag Matrix
Pivots
Figure 1 Jam Clearance Cover Support Arms and Pivots (Top View)
Xerox® Phaser® 3020 Printer Service Manual
(REP 1.2).
(Figure 1).
(Figure 1).
Support Arms
Top Cover Removal
1. Remove the Left and Right Side Covers
2. Remove the Rear Cover (REP
3. Remove the Front Cover (REP
4. Remove the Jam Clearance Cover.
5. Disconnect the Control Panel PWB connector from the Main PWB
6. Remove the Top Cover.
Connector
Figure 2 Control Panel PWB Connector
Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the PWB to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
Install the components in the reverse of removal.
June 2014
4-5
(REP 1.2).
1.3).
1.1).
(Figure 2).
Repairs
REP 1.4