Factory Settings - Pioneer FX-MG8037ZT/EW Service Manual

1
7.4 NOTES ON SERVICING
A
7.4.1 CLEANING
Before shipping out the product, be sure to clean the following portions by using the prescribed cleaning tools:
Portions to be cleaned
CD pickup lenses
B
Portions to be cleaned
Cassette heads
Pinch rollers
Capstans

7.4.2 FACTORY SETTINGS

C
- When the Repair is Complete
When the Repair is Complete, make the CD mechanism ready for transportation.
(to prevent damage during shipment)
Remove all discs loaded in this product, before disconnecting the power
-
D supply connector .
Set this product to the "Shipment mode" and
-
then disconnect the power supply connector
-
before shipping.
-
Setting the "Shipment mode"
-
Switch ACC OFF, and then, while simultaneously pressing the "SEEK UP" (or "TUNE UP" ) and
-
"DISC"buttons, switch ACC ON.
-
E
F
100
1
2
Cleaning tools
Cleaning liquid : GEM1004
Cleaning paper : GED-008
Cleaning tools
Cleaning paper : GED-008
Turning on "Shipment mode"
Confirming "Shipment mode" setting
-
During Shipment mode setting the CD loading door indicator flashes.
-
when shipment mode setting is completed, it stays lit.
-
(If the radio unit itself has a display, "SHIP" is indicated.)
-
After disconnecting the power supply connector and removing this product,
-
confirm that you can see a metal plate through the hole near the "SHIP"
-
mark on the rear chassis.
-
Confirm that the door of the CD player is closed.
-
2
3
FX-MG8037ZT/EW
3
4
4