Sony MHC-GNZ55D Operating Instructions Manual page 16

When connecting a video deck
Connect the video deck to the TV using a
video cord (not supplied). However, do not
connect this unit to the TV through the
video deck. Otherwise, you may experience
video leakage when watching video images
from this system. Connect this unit directly
to the TV as shown below.
Video deck
Tip
(Except for MHC-GNZ55D)
For higher quality video images:
– Use the optional component video cords to
connect the COMPONENT VIDEO input jacks
on your TV to the COMPONENT VIDEO OUT
jacks of this unit. If your TV is compatible with
progressive format file signals, use this
connection and set to progressive format
(page 21).
– You can use an optional S video cord to connect
the S VIDEO input jack on your TV to the S
VIDEO OUT jack of this unit.
3 Connect the FM and AM antennas.
Set up the AM loop antenna, then connect
it.
AM loop antenna
16 GB
TV
Unit
Do not connect
directly
Extend the FM lead
antenna horizontally
4 For models equipped with a voltage
selector, set VOLTAGE SELECTOR to
the position of your local power line
voltage.
Depending on the model, the VOLTAGE
SELECTOR may differ.
VOLTAGE SELECTOR
* Saudi Arabian model : 120 - 127V
5 Connect the power cord to a wall
outlet.
The demonstration appears in the display.
When you press ?/1
and the demonstration automatically ends.
If the supplied adaptor on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adaptor).
For Saudi Arabian model, see "Note on
power cord plug shapes" on page 2.
6 (Except for Latin American and
Russian models)
Set the color system to PAL or NTSC
depending on the color system of your
TV.
The default setting for color system is
different depending on the area.
Each time you perform the procedure
below, the color system changes as follows:
y
NTSC PAL
Use the buttons on the unit for the
operation.
1
Press ?/1 to turn off the system.
2
Press ?/1 while holding down X.
The system turns on automatically and
the color system is changed.
"COLOR NTSC" or "COLOR PAL"
appears in the display.
220V
240V
120V *
, the system turns on