Sony MHC-D90AV Operating Instructions Manual page 10

Step 4: Presetting radio stations
(continued)
2
Press TUNING MODE repeatedly to
select "AUTO".
3
Turn the jog dial.
The frequency indication changes and
scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
a stereo program) appear.
AUTO
4
Press TUNER MEMORY.
A preset number appears in the display.
AUTO
5
Turn the jog dial to select the preset
number you want.
6
Press ENTER/NEXT.
The station is stored.
7
Repeat steps 1 to 6 to store other
stations.
10
To tune in a station with a weak
signal
Press TUNING MODE repeatedly to select
"MANUAL" in step 2, then turn the jog dial
to tune in the station.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(Except for the Middle Eastern model)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
TUNED
STEREO
the power. While holding down the ENTER/NEXT
VOLUME
button, turn the power back on. When you change
MHz
the interval, AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
Preset number
occurs.
TUNED
STEREO
VOLUME