Usb Device - Sony CMT-MX700NI Operating Instructions Manual

The iPod/iPhone does not function.
,
Make sure the iPod/iPhone is connected securely.
,
Make sure the iPod/iPhone is updated with the latest
software. If not, update the iPod/iPhone before using
with the system.
,
Because the operation of the system and the iPod/
iPhone are different, you may not be able to operate
the iPod/iPhone using buttons on the remote or unit.
In this case, use the control buttons on the iPod/
iPhone.
,
Remove the iPod/iPhone, then reconnect it.
The iPod/iPhone cannot be charged.
,
Make sure the iPod/iPhone is connected securely.
,
You can use the system as a battery charger for iPod/
iPhone only when the system is on.
The ring volume of the iPhone does not
change.
,
Adjust the ring volume on the iPhone.

USB device

The connected iPod/iPhone or USB device is
not being charged, when both are connected
at the same time.
,
You cannot charge an iPod/iPhone and a USB device
at the same time.
Are you using a supported USB device?
,
If you connect an unsupported USB device, the
following problems may occur. Check the
information on the websites about compatible USB
devices with URLs listed under "Playing a file on a
USB device" (page 35).
• The USB device is not recognized.
• File or folder names are not displayed on this
system.
• Playback is not possible.
• The sound skips.
• There is noise.
• A distorted sound is output.
"Over Current!" appears.
,
A problem has been detected with the level of
electrical current from the
the system and remove the USB device from the
(USB) port. Make sure there is no problem with
the USB device.
If this display pattern persists, contact your nearest
Sony dealer.
60 GB
(USB) port. Turn off
There is no sound.
,
The USB device is not connected correctly. Turn off
the system, and then reconnect the USB device.
There is noise, skipping, or distorted sound.
,
Turn off the system, and then reconnect the USB
device.
,
The music data itself contains noise, or the sound is
distorted. Noise may have been entered when
creating music data due to the conditions of the
computer. Create the music data again.
,
The bit rate used when encoding the files was low.
Send files encoded with higher bit rates to the USB
device.
"Reading" is displayed for an extended time,
or it takes a long time before playback starts.
,
The reading process may take a long time in the
following cases.
• There are many folders or files on the USB device.
• The file structure is extremely complex.
• Not enough free space in the memory.
• The internal memory is fragmented.
Erroneous display
,
Send the music data to the USB device again, as the
data stored in the USB device may have been
corrupted.
,
Only alphanumerical character codes can be
displayed by this system. Other characters are not
displayed correctly.
The USB device is not recognized.
,
Turn off the system and reconnect the USB device,
then turn on the system.
,
Check the information on the websites about
compatible USB devices with URLs listed under
"Playing a file on a USB device" (page 35).
,
The USB device does not work properly. Refer to the
operating manual supplied with the USB device for
how to deal with this problem.
Play does not start.
,
Turn off the system and reconnect the USB device,
then turn on the system.
,
Check the information on the websites about
compatible USB devices with URLs listed under
"Playing a file on a USB device" (page 35).
,
Press N to start playback.
Play does not start from the first track.
,
Set the play mode to Normal Play mode.