Panasonic CY-TV7000W Service Manual page 14

Adjustment No.Adjustment
Item Point
TINT 10 Remote
Controller
Color Bar 11
Confirmation
Flicker 12 Remote
Controller
8.2. TUNER BLOCK [E-8712A]
Test Point
TP982 (G) Adjust the remote-controller so that
/ TP952 amplitude of four waveforms is same. / If the
(VGL) / TINT adjustment is no satisfied, readjust
TP984 step 9. / After second readjustment, near flat
(VGND) waveforms.
Confirm that the color bar is displayed
correctly.
Select the Flicker Adjustment, the unit is set
in zoom screen automatically. / Adjust the
remote-controller so that 3 bright bars are
not flicking.
14
Adjustment Method Remarks
Color Bar Signal
Generator / Chroma
Signal:ON / White
Level:75% / Apply
trigger at TP952.
Notes:
1. Repeat steps 9 and
the standards are satisfied.
2. Waveform should
adjusted in center
Color Bar Signal
Generator / Chroma
Signal:ON / White
Level:75%
Color Bar Signal
Generator / Chroma
Signal:ON / White
Level:75%
Note:
1. Observe the monitor
in front view