Panasonic CY-TV7000W Service Manual page 11

Adjustment No.Adjustment
Item Point
Test 3 Remote
Mode Controller
CONTRAST 4 Remote
Controller
Test Point
1. Press the TEST button of remote-controller over 2 sec to set
Setting
in test mode.
Menu
2. Select a desired adjustment item by up or down button, and
press ENTER button to decide, as shown in below. / (During
the setting menu screen, the unit is changed to VTR mode.)
3. Apply the video signal into VTR IN Connector.
4. In case of remote-controller built-in FUNCTION button, press
the button to switch adjustment item in order.
TP982 (G)
Adjust WP(White Peak) level to 3.2V.
TP952
(VGL) /
TP984
(VGND)
11
Adjustment Method Remarks
Color Bar Signal
Generator / Chroma
Signal:OFF / White
Level:100% / Apply
trigger at TP952
Notes:
1. Repeat steps 4 and
the standard are satisfied.
2. Waveform should
adjusted in center