Table of Contents
Advertisement
Hot Keys to enter Factory Mode (T80, T90, T91, T98, S80, S81, T90A,T91A) (For TW90,
TW90A & SW80, it should have signal input)
[Press Volume button, set value to 9 and press "On/Standby", "Input" and "Setup" button
simultaneously.]
Repeat the above-mentioned procedure in the bracket three times.
Hot Keys to enter Factory Mode (MT200, MT400)
[Press the "ON/STANDBY" button and then press "Set up", "Input" and "Up" (
simultaneously.]
Repeat the above-mentioned procedure in the bracket three times.
1.
Press "INPUT" and "Up" button simultaneously to enter the keystone calibration menu.
2.
Press "INPUT" and "Down" button to enter Burn-in mode menu.
3.
Press "INPUT" and "Right" button to enter test pattern menu.
4.
Press "Return" and "Up" button to enter Display the service status.
5.
Press "Return" and "Left" button to enter Display the CW index delay menu.
3-4.1
Keystone calibration menu (Except MT200, MT400)
(Press "INPUT" and "UP" button simultaneously to enter the keystone
calibration menu)
KC0
KC1
KC2
KC3
Note :
There should be values in keystone calibration menu; otherwise Auto keystone and
Auto setting will not function.
Key :
Up/Down
Enter
Setup
a.) Horizontal calibration
Requirement:
Put the projector on the stand which is horizontally and is not tipped (0 +/- 0.1 degree)
Procedure:
Choose KC0.
Execute automatic calibration.
If adjustment is successfully completed, values will change from default value "0".
If it failed, values don't change.
xxx
xxxxx
xxx
xxxxx
xxx
xxxxx
xxx
xxxxx
Choose an item with cursor
Execute automatic calibration
Initialize adjustment values
xxxxx
xxxxx
xxxxx
xxxxx
3-10
) buttons
Toshiba Series
Advertisement
Table of Contents
