2. Open the card remote control unit holder.
3. Unscrew the 2 screws fixing the connector panel.
4. Disconnect the connectors from/to the A-Module.
5. Unscrew the 5 screws and remove the A-Module.
5.4. Removal of Z3-P.C.Board
1. Remove the upper cover according to the section 5.2. "Removal of
Upper Cover".
2. Remove the A-Module according to the section 5.3. "Removal of A-
Module".
3. Unscrew the 1 screw fixing the Z3-P.C.Board.
4. Disconnect the connector and remove the Z3-P.C.Board.
5.5. Removal of K-P.C.Board
1. Remove the upper cover according to the section 5.2. "Removal of
Upper Cover".
MC-Service
9