Table of Contents
Advertisement
2. Remove the A-Module according to the section 5.3. "Removal of A-
Module".
3. Unscrew the 1 screw and remove the connector panel.
4. Unscrew the 2 screws fixing the K-P.C.Board unit.
5. Disconnect the connector and remove the K-P.C.Board unit.
6. Remove the barrier for insulation.
Note:
- Above procedure (steps 1-6) becomes possible to replace
components of the K-P.C.Board.
7. Unscrew the 2 screws fixing the K-P.C.Board.
8. Unsolder terminals of the power input socket (AC IN).
9. Unsolder terminals of the MAIN POWER switch and remove the K-
P.C.Board.
5.6. Removal of Z2-P.C.Board
10
Advertisement
Table of Contents
