Replacement Of Outside Holder T And Eyepiece Outer Ring - Sony DXF-701 Service Manual

4. When installing the VF loupe, reverse the above
procedures.
1 1 1 1 1 When installing the VF loupe, ensure the
Note:
direction of VF loupe. (Refer to Item 2-3-3.)
2 2 2 When installing eyepiece inner ring, ensure 2 2
the inserting position of friction spring and
hold it by finger. Match boss of portion D
and insert the inner ring to the outer ring.
Eyepiece
inner ring
D
Friction spring
B
Eyepiece inner ring
• Optional VF loupe
There are two kind of VF loupes as optional accesory.
Use a VF loupe to match your visibility range.
VF loupe for aged eyes;
–2D to +1D (Sony part No. 3-725-276-01)
–0.5D to +3D (Sony part No. 3-176-501-01)
(For reference) Standard ; –3D to 0D
2-4. REPLACEMENT OF OUTSIDE
HOLDER T AND EYEPIECE OUTER
RING
1. Remove the Outside holder T referring to Section 2-2-
2. "Replacement of CRT/DY Ass'y".
2. Push two pins to portion A by minus screw driver as
shown in Figure.
A
Pin
Minus screw driver
Outside holder T
2-4 2-3 (E)
D
B
Friction spring
Pin
3. Remove a screw, washer and two hinge springs. Then,
remove the outside holder T and eypiece outer ring as
shown in Figure arrow.
Outside holder T
4. Pull out two pins.
Pin
5. Replace outside holder T or eyepiece outer ring to new
one. Insert two pins to portion B by minus screw driver
as shown in Figure.
Pin
Eyepiece outer ring
Hinge springs
Pin
Pin
B
Pin
DXF-701 (UC)
DXF-701CE (CE)