Care And Maintenance - Britax BOULEVARD CS User Manual

Care and Maintenance

Cover Removal
1 Remove the infant body pillow.
2 Loosen the harness by lifting the harness
adjuster lever while pulling both shoulder
straps forward as far as possible.
3 Release the chest clip and unbuckle the
harness.
4 Unhook the shoulder straps from the
harness yoke on the rear of the child seat
(Fig. A).
5 Pull the upper harness straps through the
head restraint and cover to the front of the
child seat.
6 Recline the child seat.
7 Locate the metal buckle strap retainer on the
bottom of the child seat.
8 Pull the retainer away from the child seat to
loosen.
9 Turn the retainer so the short side will fit through the slot in the child
seat shell (Fig. B).
10 Push the retainer through the slots in the shell and cover, to the top
of the child seat.
11 Remove the head restraint portion of the cover. Remove the energy-
absorbing foam from the head restraint and set aside.
* Be careful not to damage the energy-absorbing foam.
12 Gently remove the upper portion of the cover by pulling it from
behind the side air cushions and then around the head restraint.
13 Pull the lower harness straps, buckle tongues, HUGS
and chest clip through the lower slots in cover.
14 Remove the entire cover from the child seat.
36
Cleaning the Cover
•
•
•
Refitting the Cover
a
To refit the cover, reverse the directions on page 36. Make sure that the
shoulder straps are not twisted, and are properly threaded through the
chest clip, HUGS
Cleaning the Shell
•
•
•
b
Cleaning the Harness
•
•
•
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and free of
food, drink or other debris. If debris is present, it must be removed to
chest pads,
™
prevent interference with the adjuster mechanism.
•
•
•
•
HAND WASH using cold water and mild soap.
LINE or LIE-FLAT DRY to prevent the cover from shrinking.
DO NOT bleach, machine wash, machine dry or iron.
chest pads, cover, foam, and shell.
TM
SPONGE CLEAN using warm water and mild soap.
TOWEL DRY
DO NOT use solvents or abrasive cleaners.
SPONGE CLEAN using warm water and mild soap.
TOWEL DRY
DO NOT bleach, machine wash, machine dry, iron, or disassemble
the harness.
BRUSH AWAY LOOSE DEBRIS using a soft-bristled brush.
SPONGE CLEAN using warm water and a mild soap.
TOWEL DRY
DO NOT use solvents, abrasive cleaners or disassemble the harness.
Care and Maintenance
37