Warning! Safety Instructions - Marshall Amplification 2555X Quick Start Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH

WARNING! SAFETY INSTRUCTIONS

Please read this manual carefully before plugging in. Follow all instructions and heed all
warnings.
Warning: please refer to full details in separate 
Important Safety Instructions leaflet 
(document number CATS-00158).
MAINS INPUT & FUSE
The specific mains input voltage rating that your 
amp has been manufactured for is indicated on 
the rear panel of the amp. Your amp is provided 
with a detachable mains (power) lead, which 
should be connected to the mains input socket 
on the rear panel of the amp. 
The correct value and type of mains fuse is 
specified on the rear panel of the amp. Never 
attempt to bypass the fuse or fit one of the 
incorrect value or type. 
Warning: your amp must be switched off and 
disconnected from the mains electricity supply 
before you check and/or change any fuse.
IMPORTANT SET UP INFORMATION
1.  Connect one or two speaker cabinets to the 
speaker outputs. 
Warning: failure to do the above may damage 
your amp. When connecting a speaker cabinet 
make sure that you use a proper speaker cable. 
Never use a screened (shielded) guitar cable for 
this purpose.
2.  Ensure that both the power switch and 
standby switch are set to the off position.
3.  Connect the supplied mains (power) lead 
into the power inlet on the rear panel first 
and then into an electricity outlet.
4.  Plug your guitar into the input on the front 
panel.
5.  Turn the power switch on and wait a couple 
of minutes.
6.  Select either high (100W) or low (50W) 
2
output using the output switch.
7.  Turn the standby switch to the '1' position.
8.  Turn the volume up to your preferred level 
and you're ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched off, 
unplugged from the mains electricity supply and 
all removable cables have been disconnected 
from your equipment before attempting to 
move it.
Only move the amp on its own. Do not attempt 
to move it while it is stacked on top of a cabinet 
or other equipment.

Advertisement

Table of Contents
loading

Table of Contents