Troubleshooting; Machine Storage - Bissell 1370 Series User Manual

M
aintenance and care

Machine storage

Put the unit away in a closet or basement for
the next use. Store cleaner in a protected, dry
area. Since this product uses water, it must not
be stored where there is a danger of freezing.
Freezing will damage internal components and
void the warranty.
T
roubleshooting
Reduced Spray OR No Spray
Possible cause
1.
Bladder may be empty
2. 2-in-1 tank may not be seated properly.
3.
Pump may have lost prime.
4.
The pump belt may be broken.
A.
DirtLifter PowerBrush Does Not Turn
Possible cause
1. The brush belt or pump belt is off or broken.
w w w . b i s s e l l . c o m
ug120-4072_1370-1622_908.indd 9
B.
Slots Pump Belt
WARNING:
To reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.
Remedies
1. Turn power switch OFF (O); Refill bladder
with clean hot tap water.
2. Turn power switch OFF (O); remove tank
and reseat tanks.
3. Turn power switch OFF (O); after 1 minute
turn ON (I) and depress spray release trigger.
4. Turn power switch OFF (O) and unplug from
the outlet. To check if a pump belt has broken,
you will need a flat head screwdriver.
A. Insert the blade end into the slot of the
belt access door to release. Examine the
belt for breakage. You should be able to see
the pump belt looped around the motor shaft.
If it is broken or missing, please refer to
Replacement Parts on page 11.
A replacement belt may be ordered at
www.bissell.com or by calling BISSELL
Consumer Services at 800-237-7691.
Complete installation instructions
will accompany the replacement belt.
B. When replacing belt access door be
sure to line up slots of belt access door with
slots in machine, slide door into place and
snap shut.
Remedies
1. Refer to Remedy 5 above to check if brush
belt or pump belt is broken.
8 0 0 . 2 3 7 . 7 6 9 1
9
10/14/08 12:55:18 PM