Safe Display - Honeywell BW GasAlertMicro User Manual

GasAlertMicro
User Manual
In the event of an alarm condition, and if the low and high
gas alarms are set to latch, the audible and visual alarms will
persist until the alarm is acknowledged.
To enable/disable the latched alarm option, complete the
following:
1. From the user options menu, use G or H to scroll
to the LAtchin ALArmS option.
2. Press C to select the option.
The LCD displays the current mode (On or OFF)
and then returns to the FiniSh OPtionS screen.
18
or
3. Use G or H to scroll to a new user option, or press
C to exit user options and return to normal
operating mode.

Safe Display

The SAFE dISPLAY option automatically notifies that only
normal ambient conditions exist and that there are no gas
hazards monitored. This option can be enabled or disabled.
If this option is enabled, when the detector is in normal
operating mode and when no hazards are measured, SAFE
scrolls across the LCD continually.
SAFE does not display while functions are being performed.
This option is automatically disabled in stealth
mode.
If any gas is present, such as
• readings are other than zero for toxic combustible
gas(es), or
• the oxygen reading is other than 20.9%,
the LCD displays the gas levels for all of the sensors. When
the levels return to normal, SAFE again scrolls across the
screen.
Note