Table of Contents
Advertisement
UsInG THe Web-based adVanCed UseR InTeRfaCe
sections
table of contents
setting Up a bridge between your Router and a secondary access Point
Bridging your Belkin Router to a secondary Access Point requires that you access the Router's Advanced Setup Utility and enter the MAC
address of the Access Point in the appropriate area� There are also a few other requirements� Please be sURe To folloW THe sTePs
beloW, CaRefUlly�
1�
Set your Access Point to the same channel as the Router� By
default, the Router and Access Point channels are set to channel
11 at the factory� If you have never changed the channel, you don't
need to do anything (for more information on changing channels,
see page 48 of this User Manual)�
G Wireless Router
1
2
3
4
5
6
2�
Find the Access Point's MAC address on the bottom of the Access
Point� There are two MAC addresses on the bottom label� You will
need the MAC address named "WLAN MAC Address"� The MAC
address starts with 0030BD and is followed by six other numbers
or letters (i�e� 0030BD-XXXXXX)� Write the MAC address below� Go
to the next step�
62
7
8
9
10
Advertisement
Table of Contents
