Advertisement
TROUBLE
INSPECTION
INSPECTION
INSPECTION
Drain takes time too
long.
Note: In draining, the water level sensor can
Note: In draining, the water lever sensor can
not reset in 10 minutes.
not reset in 8minutes.
The number window LED display
The number window LED display
abnormal code:
abnormal code:
on and off at the same time and the
on and off at the same time and the
electric buzzer sounds to indicate a
electric buzzer sounds to indicate a
problem.
problem.
• If the Drain Hose is too long or high, it may
make draining impossible.
• The extend Drain Hose to a maximum long of
3 meters and maximum high of 10
centimeters.
e. Spin Drying
Spin drying cycle
Does safety
does not work.
device work?
Note:
1. The safety switch works 3 times
continuously or works 1 time in the
single
program of
number window LED display abnormal
code:
and begin blinking on and off
at the same time and the electric buzzer
sounds to indicate a problem.
2. Do not disconnect the wire from the
capacitor, because
this wire acts as
de-pressing noise from outside to the
micro-computer.
All manuals and user guides at all-guides.com
Valve bellows is deformed.
Drain hose ass
deformed.
Hose is connected in the
wrong way.
Hose is too long or position of
and begin blinking
and begin blinking
hose is too high.
Yes
Machine inclines.
No
The V-belt is slipping.
The V-belt is snapped.
Small pulley mounting
.
spin-dry
The
screw is loosed.
Motor is disconnected or
burnt.
Capacitor is broken or
disconnected.
Bearing ass
Torque motor is defective.
Brake lever is defective.
Thermostat on motor is
opened.
Poor
connectors
Control circuit board is
defective.
CAUSES
Replace.
'
y is
Repair or replace.
Repair.
Repair.
Replace with level.
Adjust the motor
position.
Replace.
Tighten up.
Replace.
Replace.
'
y is defective.
Replace.
Replace.
Repair or replace.
Repair or replace
after cooling down.
contact
of
Repair or replace.
Replace.
WWA-780
REMEDY
Advertisement
