Table of Contents
Advertisement
Before use
Before using your dishwasher for the
first time:
1. Ensure that the electrical and water connections
comply with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and
then fill with salt
5. Fill the rinse aid dispenser.
Setting the water softener
The dishwasher is equipped with a water softener
designed to remove minerals and salts from the
water supply, which would have a detrimental or
adverse effect on the operation of the appliance.
The higher the content of these salts, the harder
your water is.
Water hardness is measured in equivalent scales,
Clarke degrees, French degrees and PPM (parts per
Million).
The softener should be adjusted according to the
hardness of the water in your area. Your local Water
Authority can advise you on the hardness of the
water in your area.
The dishwasher is factory set at level 3.
If this level is not suitable for your area the softener
should be adjusted.
To select a different level be sure that
the dishwasher is off and then proceed
as follows:
1. Press Intensive 70° 80' and Normal 65°
programme push buttons simultaneously.
2. Always keeping pressed the programme push
buttons Intensive 70° 80' and Normal 65° switch
on the dishwasher by pressing the On/Off push
button.
The On/Off indicator light comes on.
At the same time, also the indicator light of the
Intensive 70° 80' push button comes on and
remains fixed for about 5 seconds, after this it
starts flashing indicating the current level of the
water softener.
All manuals and user guides at all-guides.com
29
Water hardness
German
French
Level
degrees
degrees
(°dH)
(°TH)
< 4
< 8
1
4 - 18
2
8 - 30
19 - 29
31 - 50
3
30 - 40
4
51 - 70
41 - 50
71 - 90
5
SO406
PPM
Use of
(Parts per
salt
Million)
< 80
NO
81 - 300
YES
301 - 500
YES
501 - 700
YES
701 - 900
YES
Advertisement
Table of Contents
