Operating Sequence - Electrolux ESF 4120 Instruction Book

Operating sequence

1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light will come on.
3. Check that there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms
can rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the recommended
quantity given in the Washing programmes
chart.
Close the detergent dispenser lid.
7. Close the dishwasher door
8a. Setting and starting the
programme without delay start
Press the push button corresponding to the
wanted programme: the indicator light
corresponding to the programme illuminates
and the phase indicator lights foreseen for that
programme start flashing.
All manuals and user guides at all-guides.com
38
The start of the programme will occur after
about 6 seconds from the last pressure of a
programme push button, in this time it is
possible to change programme simply pressing
the push button of another programme.
Once the programme has started the phase
indicator lights will turn off except for the phase
under way.
It is possible to interrupt the programme:
opening the door
pressing the On/Off (in this case all the
indicator lights turn off)
Close the door again o press the On/Off, the
programme will start from the point in which it
was interrupted.
8b. Setting and starting the
programme with delay start
The setting of the delay start occurs
before selecting the programme.
Press the delay start push button and
selected the desired time (3, 6 or 9 hours)
until the indicator light corresponding to the
chosen hours flashes.
Press the push button corresponding to the
required programme: the indicator light
corresponding to the programme illuminates
and the phase indicator lights for that
programme start flashing.
The start of the countdown will occur after
about 6 seconds from the last pressure of a
programme push button.
The countdown will decrease with step of 3
hours and you are informed of this by the
indicator lights of the hours.
During the countdown the only indicator lights
illuminated are the programme light and the
light of the number of hours to the start of the
programme.
Once the delayed time has elapsed the
programme will start automatically.
It is possible to stop a countdown in
progress or before it starts, simply
pressing the delay start push button
until the indicator lights of the hours are
off.