Channel Tuning Set Up - Audiovox AVT-597 Operating Instructions Manual

CHANNEL TUNING SET UP

Follow this simple procedure to make channel tuning more convenient:
1. Use the TV/CATV button on the Remote Control to select the broadcast system appropriate for your home. The
system selected will be displayed on the screen. If you have normal Broadcast TV, select "TV", if you have
Cable TV select either "STD", "HRC", or "IRC" ("STD" is used by the majority of Cable Systems. Check with your
cable operator.)
2. Press the AUTO PROGRAM button on the Remote Control Unit, you will see the TV cycle through all channels.
The built-in Microprocessor will automatically note each channel that is actively broadcasting in your area.
3. (1) Press the SKIP/SEARCH button on the Remote Control Unit until "SKIP MODE ON" is displayed on the
bottom of the screen. That's all there is to it. From now on, whenever you use the CHANNEL UP/DOWN
buttons on the front panel or the Remote control, the TV will stop only on active channels.
(2) Press the SKIP/SEARCH button on the Remote Control Unit until "SKIP MODE OFF" is displayed on the
bottom of the screen. Tune to the desired channel by direct access using 0-9 buttons on the Remote Control.
4. To erase a channel, press the ERASE/WRITE button on the Remote Control Unit until the MANUAL MEMORY
has erase displayed on the screen. To store a channel, press the button until the MANUAL MEMORY had been
added on screen.
-9-